I'm attempting to setup an intercom made by ICT. It's a simple wall mounted intercom with a single button and speaker. Press the button and it dials a phone number.
In the SIP configuration it is asking for Realm and Schema along with the usual Login ID and password.. I don't know what to put for either option and it doesn't register if I skip it. I've spoken to the people from ICT about what to use and they said it would be specific to Allworx.
Does anyone have any experience with these two settings?
If anyone is interested in helping create a new site logo please email webmaster@allworxforums.com
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
ICT Intercom
-
joeredsmith
- Posts: 2
- Joined: Thu Jan 22, 2015 3:01 pm
Re: ICT Intercom
Bump
Did you figure this out I am having the same issue.
Thanks.
Did you figure this out I am having the same issue.
Thanks.