In my setup I have the Allworx behind a Cisco Router,
I port forwarded port 8080 to the Allworx IP but I cannot
access the Allworx from outside the LAN, any ideas.
Thanks.
If anyone is interested in helping create a new site logo please email webmaster@allworxforums.com
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
Remote Admin
Re: Remote Admin
Is the WAN/Internet port on the Allworx enabled? If so, your port forwarding isn't going to do any good, because the Allworx won't know how to get back to the requesting IP.
Re: Remote Admin
Isn't that by default, I don't see any way to change it, see below.
"NOTE
In LAN Host mode the WAN interface remains enabled. The WAN Network (WAN IP Address with Subnet Mask applied) must be set to a value that does not conflict with the rest of your network."
"NOTE
In LAN Host mode the WAN interface remains enabled. The WAN Network (WAN IP Address with Subnet Mask applied) must be set to a value that does not conflict with the rest of your network."