Page 1 of 1
Remote Admin
Posted: Fri Apr 13, 2012 5:50 pm
by Coolie11
In my setup I have the Allworx behind a Cisco Router,
I port forwarded port 8080 to the Allworx IP but I cannot
access the Allworx from outside the LAN, any ideas.
Thanks.
Re: Remote Admin
Posted: Fri Apr 13, 2012 8:46 pm
by doom1701
Is the WAN/Internet port on the Allworx enabled? If so, your port forwarding isn't going to do any good, because the Allworx won't know how to get back to the requesting IP.
Re: Remote Admin
Posted: Sat Apr 14, 2012 9:27 am
by Coolie11
Isn't that by default, I don't see any way to change it, see below.
"NOTE
In LAN Host mode the WAN interface remains enabled. The WAN Network (WAN IP Address with Subnet Mask applied) must be set to a value that does not conflict with the rest of your network."