If anyone is interested in helping create a new site logo please email webmaster@allworxforums.com
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
VoIP Faxing
VoIP Faxing
Does the Allworx 48x support T.38 protocol? We would like to configure for VoIP faxing.
Re: VoIP Faxing
I haven't seen anything about T.38 in the Allworx.
You could try to configure without it and see what happens... might not be reliable though.
I have successfully used a Grandstream HT701 SIP ATA for faxing purposes. Supports T.38.
If you try that, you may need to change this setting to Yes: Loop Current Disconnect. Without that the ATA wouldn't hang up properly when the fax was complete. May be dependent on SIP provider.
You could try to configure without it and see what happens... might not be reliable though.
I have successfully used a Grandstream HT701 SIP ATA for faxing purposes. Supports T.38.
If you try that, you may need to change this setting to Yes: Loop Current Disconnect. Without that the ATA wouldn't hang up properly when the fax was complete. May be dependent on SIP provider.