We have a location that has two offices on seperate internet connections. Both offices have a tunnel to our central datacenter and can communicate with each other on the Voice VLAN that the phones ride. The allworx system however will not respond to anything in the remote office.
We have a route in the phone system pointing to the vlan gateway on the local side and then the Meraki should handle passing the traffic from there but we never see the phone system respond with any traffic destined for the remote subnet.
On the side that houses the phone system we have the subnet 172.31.31.0/25 in the other office we have 172.31.31.128/25. The phone system's IP is 172.31.31.13 and the VLan interface of the router on the phone system side is 172.31.31.12 which we have the routes pointing to.
any ideas?
If anyone is interested in helping create a new site logo please email webmaster@allworxforums.com
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.
PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.